G007-S: Error invalid output voltage

This error occurs when the voltage on the Local out exceeds 10Volts RMS, whilst the PowerRouter is in standby. This error should be resolved after restarting the PowerRouter. If it is not:

  1. Check the wiring,
  2. Check the Anti-Islanding configuration,
  3. It could be that a relay inside the PowerRouter lingers, although it should disconnect.

    If this occurs very often, replacing the Powerrouter is the only solution.
    Contact Nedap PowerRouter Support.
Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request